C-MAX dont start after ABS update

[melloon]

Hello
C-MAX 2011, after update flash in oryginal BV61-2C405-AF ABS, ABS is death. No communication
The car does not start.
I changed the module ABS, communication is ok, but car still not start.
Please help

[melloon]

I try forced updade , dont work.
Settings like in the picture. Everything set up is ok ?

[Artist]

use sbl loader and calibration file (1 !!!!)
Why do you put it in item 6?
You can try different settings, including MMBus support.
ABS is not recommended to update! Warning message warned you!
The ABS module doesn't have to be revived at all, it will be equivalent to the UCDS miracle.
I also had to replace my module!
Support for ABS update should be disabled in UCDS. There are hundreds of customers with a damaged ABS module after the upgrade.

After installing a new module, it is necessary to adapt the vin to the Abs module. I don't know if it even supports UCDS for C-Max!
Or then try Forscan. Use a free license for 2 months (if you don't)
UCDS works with this software. Try to find a solution on the Forscan Forum. UCDS is not about supporting the UK Forum. It's a system try and let you know how you turned out ...

I'm a big fan, but the reality is so ...

P.S: Try inserting module programming error images ...

[Artist]

From the data I see in the picture, I would choose the following files ...

[melloon]

there was a error of checksum in ABS module, that's why I made the update ...

[melloon]

Maybe I'm doing something wrong?

I remove fuse 19 (after ignition to ABS), click YES and put fuse back, and.... nothing is happening
Bootloader is damaged ?

ps. I try update second module, from another car and now i have two dead module
I bought a third one, but I do not know how to add it to the car

[Artist]

Try MM Can.
remove tester present service ...
Each module has its HW part number.
If you give a third module, encode the pats with Forscan ...

[kroligoff]

Not need MM-CAN (its for switch to Multimedia Bus)

Try remove power from battery and connect before on 15 sec after message

[melloon]

I tried to disconnect the battery before, without the effect
Now I put switch instead of a fuse 19

I tried to encode Forscan, without result.
No comunication with PATS, in BCM I did not find a function PATS or encode module.
You can help me how to do it with Forscan (of course with extension license)

[Artist]

Are you attempting Pats with a dead module?
That's not real!
You should have done it right after the exchange when you didn't send it back to heaven ...

[kroligoff]

Why you help forscan? Im confused , forscant cant help you!
You abs now have not correct software and freeze (prelift focus have not correct ABS modules for update)
Modules on Focus 3/CMax with *-AF or before , after update sw cant start. In update wizard show Warning before about it.
One way try reflash in "dead mode",
Remove power from ABS, Enable Ignition, after press button before 15 sec, give power on ABS. Try some runs.

[melloon]

Artist, I tried when the second module was still alive, it's obvious