UCDS Forum

Hi,

I changed the TCM of a Ford Galaxy 2.3L Duratec-HE (160PS). HW Partnumber TCM is 7G9N-14C336-DB.

In the TCM I now have the fault:
P0614: ECM / TCM Incompatible
Failure Type 0x00:
No Additional Failure Type Information for this (DTC)
Status 0xAF:
Warning lamp ON (MIL)
Fault is currently present

Donor-TCM info:
Module Name: TCMNetwork: HS-CAN Protocol: GGDS
F108ECU Network Signal Calibration NumberNo response
F111ECU Core Assembly Number7G9N-14C336-DB
F113ECU Delivery Assembly Number7G9N-14C336-DB
F124ECU Calibration Data #1 NumberNo response
F162Software Download Specification VersionNo response
F163Diagnostic Specification Version0x02
F188VehBest regards,icle Manufacturer ECU Software Number7G9N-14C337-JK
F191Vehicle Manufacturer ECU Hardware Number7G9N-14C336-DB
F18CECU Serial Number000081601560

Unfortunately original-TCM not communicating/responding so I can not check what the original software (F188) and calibration (F108) files are.

Does anybody know how I can find the correct software (F188) and calibration (F108) numbers?

Advised by Au(R)oN I tried to load the VIN on the update wizard. That resulted in "no calibrations available for this VIN".

Also advised by Au(R)oN I tried https://www.motorcraftservice.com/AsBuilt. The ab file from that site also doesn't contain calibration data either.

As it seems I can only be estimated with an equal car with equal engine gearbox setup. Does anyone have access to an equal car to check the correct software (F188) and calibration (F108) numbers for this car?

VIN: WF0MXXGBWM8S13873
Build date: december 2008
Enginetype: 2.3L Duratec-HE (160PS) - MI4
Transmission: 6-traps autom. transmission - AWF21