UCDS Forum

Hi guys,
I tried the procedure to increase the power from 150hp to 180hp of my Smax st line 150hp of 2018.
The steps followed are:
1 - Direct configuration
2 - select vehicle ==> EDGE [CD539] / S-MAX [CD390] 2015
3 - Select Module ==> ABS (F2GC - *) ==> Next
4 - ReadFrommodule
5 - Suspension, Engine Type ==> Susp_SelfLevelling & Engine_20L_I4_DW10F_180HP
6 - security Level 0x03I / O Securitylevel
7 - Write to module.............I wait for the writing operation to finish
8 - Reset module.............I wait for the operation to finish
9 - Then select PCM 2.0D EcoBlue ==> Next
10 - ReadFrom module
11 - Engine Power (PS) from 0 I put 1
12 - Write to module.............I wait for the operation to finish
13 - Reset module.............I wait for the operation to finish
14 - I turn off, turn on again I go to read the two modules and check that the writing has been done.
15 - I turn on the car, and go to test it on the road but I don't feel any change in performance ...

what did i do wrong?

feel change in performance beginning from 2500rpm...

So I read in the wiki that for ecoblue engines you have to go from 2.0D EcoBlue PANTERA DSL CR TC 2.0L 150 HP to 2.0D EcoBlue PANTHER DSL CR TC 2.0L B 180 PS
But I went to reread the module PCM and into the section Engine I already have the 2.0D EcoBlue PANTHER DSL CR TC 2.0L B ....
then I tried to put the C ...
With this I struggle to reach 180Km / h
I put the B back and with this I can easily reach 210Km / h ....
I also tried the other types of motors (D, E, J) but when I go to write the module it gives me an out of range error
What is the mystery? I bought a 150HP and have already given me a 180HP?

Nobody knows from info ?

Panther b 190ps or fokus panther D 190ps